Before starting work
In accordance with safety requirements, you need
To examine the tool. Pay attention to
The rated voltage of the network and the vibrator must correspond. It is forbidden to connect the vibrator to electric networks with the voltage and the frequency other than those indicated in the passport.
Reliable fixation of all threaded joints on the vibrator, flexible drive, tip .
The presence of high -quality grounding, lack of damage to the supply wire
The backlash of the vibrator rotor shaft should not exceed the permissible norm. The value is indicated in the passport of the device. Usually it is 1.5mm.
The vibrator before starting work should be attached to the base, the operation of an unknown vibrator is not allowed. Fixation is carried out using nuts, tightened using a dynamometric key. The values of the delaying moments are given in the passport of the product. Under the nuts there should be a flat puck and a puck-groover to prevent unscrewing the nuts during the operation of the tool. The plate should be set in level. So that the vibrator shaft during operation is strictly horizontal.
It is not allowed to lay the supply electrolyte with tension. The wire should not be twisted.
Maintenance
To prevent breakdowns and quick failure, it is necessary to maintain the tool maintenance.
Examine the device daily, delete pollution. Check the reliability of the mounting of the vibrator to the installation plate.
Monthly check the integrity of the insulation of the supply wires and other conductive parts, the purity of contact compounds, the integrity and reliability of the attachment of the terminal group and grounding, the absence of short circuit and other conductive parts.
Storage and transportation
Keep a non -working vibrator in a specially adapted dry, warm room.
Humidity and temperature, which is allowed in the room, must correspond to the regulated values.
It is not allowed to lay vibrators in two or more rows.
Electromechanical vibrators “NBOBOT” VE-98; VE-98A general purpose. During their manufacture and acceptance, all the requirements of state regulatory documents for this kind of instruments are maintained. Based on the results of acceptance, they comply with the standards and other technical documentation and are suitable for operation in accordance with all technical standards.
