One of the most important stages when laying ceramic tiles on the wall is the preparation of glue, because if you cook it incorrectly, problems may appear regarding the quality of tile strengthening. A small amount should be made in a small amount to use it without a trace in a couple of hours, since after three hours the glue dries up.
In addition, it is necessary to accurately adhere to the ratio indicated in the instructions, as well as thoroughly stir the resulting mixture. Then you need to wait until it is infused and stir well again. After that, you can already work with the adhesive mixture. It should be applied to the base of the wall using a toothed spatula. Thanks to the teeth on it, the glue is distributed evenly in waves. When repairing in the house, one should not forget about its protection. By the way, wireless miniature surveillance cameras will help in this, which can be easily recognized by going to the site.
Then you can proceed to the direct installation of finishing material. It is laid to the wall with the lower line of the reverse side at an angle of 85 degrees. Then it must be pressed quickly from the bottom up and set it in the right place. While the glue did not have time to freeze, you need to remove excess glue.
In addition, we must not forget about the seams between individual tiles. They are usually controlled using special crosses designed to install tiles. Thanks to this, you can get even and the same seams. At the end, the tiles that are trimmed should. To cut the material, use a special tool – a tile cutter.
